Inspection before PC200-7 excavator starts

It mainly explains which two points of inspection work need to be done before the PC200-7 excavator starts, to avoid common faults of the excavator.

The details of the inspection before the start of the PC200-7 excavator spare parts are as follows:

1 Before the engine starts, it is necessary to conduct a patrol inspection to observe the appearance of the vehicle, check whether the bolts and nuts are loose, and whether the oil fuel cooling water leaks. Be careful to check for the presence of dirt, oil and fuel leaks around the high temperature parts of the engine.

2 Check before work: Check the oil quantity in the oil tank and look at the oil level. Check the supplementary cooling water to confirm whether there is cooling water in the auxiliary tank. If the auxiliary water tank is insufficient, add water; drain the water in the tank, open the collapse on the right side of the body, and then unscrew the drain valve located behind the hydraulic tank. Check the oil-water separator. If the float ring is not deep enough to the baseline, it is suitable. Check the electrical circuit, check the fuse for damage, the circuit is short-circuited, and check the terminal for looseness. https://jnjmzm.wixsite.com/sdjygcjx