How to manage excavator fuel, oil, smooth grease and filter

1 Excavator fuel, oil, smooth grease and filter core management:

Excavator fuel, oil, smooth grease and filter management can not only reduce the occurrence of excavator failure, improve the efficiency of excavator operation, reduce the cost of operation, but also extend the service life of the excavator spare parts. Engine fuel, oil, smooth grease and filter management are essential tasks.

2 How to manage excavator fuel.

Excavator fuel management should be based on the different operating environment of the excavator, to choose different grades of qualified fuel. If the selected fuel is not suitable for the engine is harmful.

The diesel used in the original excavator spare parts should not be mixed with impurities, dirt and water. Otherwise, the fuel pump will wear out prematurely. The excavator driver should fill the fuel tank after the daily operation, avoid water droplets on the inner wall of the tank, and turn the fuel on before the daily operation. The drain valve at the bottom of the tank is drained.

2. How to manage the engine oil, hydraulic oil and gear oil of the excavator.

Do not mix oils of different grades and grades. Be sure to clean with oil to avoid mixing of impurities. Use different grades of oil according to the ambient temperature and use. (When the ambient temperature is high, the viscosity is high. If the ambient temperature is low, the viscosity is absolutely selected. Smaller oil).

The viscosity of the gear oil is absolutely large, in order to comply with the larger transmission load, the viscosity of the hydraulic spare parts oil is absolutely small, in order to increase the resistance of the liquid activity.

How to manage the smooth grease of the excavator.

When storing smooth grease, be careful not to mix dust, sand, water and other impurities.

How to manage the excavator filter.

The filter element acts as a filter to filter impurities in the oil path or the gas path, preventing impurities from invading the fragmented exterior and forming a fault. The pure filter element conforming to the machine rules is used, and various filter elements should be changed according to the requirements of the filter. When changing the filter element, it should be reflected whether there is any The metal is attached to the old filter element. If metal particles are found, it should be diagnosed and improved. https://jnjmzm.wixsite.com/sdjygcjx