5 wrong operations will make the cylinder abolish

01. The working device is not fully recovered and walks.

   When the excavator working device is not fully retracted, the bucket is easy to hit the rock, and the piston rod of the cylinder will have a large conformity, resulting in damage inside the cylinder and cracking around the pin shaft.

02. Excavator spare parts. Do not use the walking force to excavate. When the arm cylinder is quickly retracted, if it is excavated by the walking force, the walking force will exceed the bending ratio of the bending plum, which will cause bending. Usually, the working cannot be performed with the walking force.

03. Original spare parts. The frequency of the breaker is too high for a long time to break. The piston rod is vibrated at high frequency and the force is too large, which easily causes the piston rod to bend and break.

04. Komatsu excavator spare parts. The cylinder rod is telescopic to the limit for excavation work. The hydraulic cylinder of the excavator is telescoped to the end position for excavation operation. In this case, the impact of the working cylinder, the frame, and the impact of each shaft pin may cause damage inside the cylinder. It also affects other hydraulic components.

05. Komatsu spare parts. After the crawler does not float, do the excavation work and use the power of the excavator body to float up to carry out the excavation work. When the bucket and the rock are separated, the vehicle body will have a large load on the bucket, the breeding, the frame, the slewing support, etc., and it is easy to cause damage.